Fantastic Tips About How To Clean A Rifle Properly
The first step to actual barrel cleaning it to push a patch completely soaked in bore solvent down the barrel with the jag.
How to clean a rifle properly. This article was first published in 2016 and has been updated. We’ll cover basic field stripping in this article. It all starts with the right tools and a solid understanding of what you’re trying to accomplish.
5 steps to proper gun cleaning for rifles. Use a cleaning rod and solvent to clean the barrel, then reassemble the rifle and apply a light coat of oil to prevent rust. How to clean a rifle bore in 6 steps step 1:
Before we hop into some procedural content, you’re going to need to prep your workspace with the right tools and supplies. If your rifle uses a detachable magazine, wipe it down well. Due to the variety of rifles, complete disassembly of the firearm aren’t within the scope of this article.
A proper cleaning station can make the process much easier and safer. Having made sure the rifle is unloaded, clamp it in the gun vise and remove the bolt. If you scratch or crack the crown, you’ll mess up with your rifle’s accuracy.
This may take 20 or more repetitions on a really dirty rifle. During each cleaning, inspect all parts of cracks, burrs and general wear and tear that may bring your rifle out of spec. How to clean rifle bolt components.
These are just the essentials you’ll need. When you apply solvent to a patch, pour it over the container. Then disassemble the bolt and remove any excess oil and debris.
Keep a small glass container in your cleaning kit with a dozen patches inside. Now, wet a patch with powder solvent, impale it on a jag (do not use a slotted tip) of a. Set up your cleaning station.
The only way to clean and polish your rifle properly is by having everything you need and having them right. Let it soak, then push clean patches through. Use a can of kroil oil with it, too.
Here are some of our top recommendations to make cleaning your 22lr bolt action simpler: For cleaning, a carbon cleaner is a necessity along with a degreaser, gun oil and a little lubricant. First, attach a clean patch to the end of the jib on the tip of the cleaning rod, soak it with bore cleaner, push it through the barrel, and remove the patch before withdrawing the cleaning rod.
Go for something for the caliber of your rifle. Make sure to start from the rear side, as the crown occupies the muzzle end of the barrel. Remove dirt and debris from the bolt.